Overview
SabreBond PU6000 is a high-performance single-component (1K) moisture-curing polyurethane adhesive for lamination applications. It has been developed primarily for applications in the laminating and panel manufacturing industries where it is used for bonding foam insulation materials to a wide variety of woods, metals, and plastics.
Available in:
200L Drum
Applications
- Structural insulated panels (SIPs)
- Insulated building panels
- Decorative panels
- Doors
See all applications in our Technical Data Sheet
See all applications in our Technical Data Sheet
How to use
- Substrate Preparation:
Materials to be bonded must be free from surface contamination, dust, grease, etc.
Metals should be kept in a warm place prior to bonding to avoid shock cooling of the bond line which leads to protracted curing times. - Application:
The adhesive should be applied to one surface only. The amount of adhesive used will depend upon the porosity of the substrate.
If required, a fine mist of water should then be applied to the bondline at a coating weight 10% that of the adhesive coat weight applied. - Assembly:
Panels may be assembled immediately after adhesive application or left for the indicated open time (Note: The open time changes with temperature. This should be monitored)
- Pressing:
The panels should be cured in a vacuum or hydraulic press with heat application, if desired to accelerate cure.
Sufficient even pressure must be applied to keep the components in intimate contact during the curing cycle.
The pressure required will depend to a great extent on the nature of the substrates but is usually in the range of 10-14 psi (0.7 – 0.9 kg/sq.cm.).
Downloads
FAQs
Is PU6000 available in a variety of working times?
Yes, a wide range of working times are available within the range, and this can be customised to fit unique customer requirements.
Will temperature and humidity affect the working parameters of the adhesive?
Yes. The adhesives cure via a chemical reaction with moisture. Common with most chemical reactions, the rate of curing is affected by temperature and humidity. Applying water brings the humidity to 100%, and therefore eliminates that factor, but the open time and press time are still affected. Our TDS sheets provide guidance on what the required open time and press time are, at the temperatures present during use of the adhesive.
What is the recommended adhesive coat weight?
The amount of adhesive used will depend upon the porosity of the substrate, but normal coverage rates are between 100gsm and 250gsm.
Does PU6000 contain any solvents?
No, the adhesives contain no solvents and is non-flammable, therefore sensitive plastics are not prone to attack.
What is the shelf life of PU6000?
Standard shelf life is approx. 6 months from the date of manufacture.
Find the quality product you need
Product Finder